研究生: |
鍾四維 Sz-wei Jung |
---|---|
論文名稱: |
高效能LED路燈之輸出疊加式單級驅動電源研製 Study and Implementation of High-Performance Cascoded-Output Single-Stage LED Street Light Drivers |
指導教授: |
羅有綱
Yu-Kang Lo 邱煌仁 Huang-Jen Chiu |
口試委員: |
鄭世仁
none 林景源 none |
學位類別: |
碩士 Master |
系所名稱: |
電資學院 - 電子工程系 Department of Electronic and Computer Engineering |
論文出版年: | 2013 |
畢業學年度: | 101 |
語文別: | 中文 |
論文頁數: | 89 |
中文關鍵詞: | LED路燈 、功率因數 、返馳式轉換器 |
外文關鍵詞: | LED streetlamp, power factor, flyback converter |
相關次數: | 點閱:231 下載:5 |
分享至: |
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本論文研製一種高性能LED路燈電源架構,文中實作200 W LED路燈驅動電源,以驗證所提出之單級返馳式轉換器創新架構。分別設計150 W定電壓與50W定電流返馳式轉換器各一台,採用並聯輸入、串聯輸出並加入輸入電流波形修正電路的方式,實現高功率LED路燈驅動電源。本論文內容首先針對返馳式轉換器的操作原理進行理論分析,而後說明定電壓返馳式與定電流返馳式轉換器整合後功因修正之電流波形修正方法,詳細說明控制器與元件的設計原則。最後實作一額定輸出功率200 W、額定輸出電流0.7 A之雛型電路,驗證本文所提架構之可行性與優越性。
This thesis studyies and implements a high-efficiency power supply for driving a 200-W LED streetlamp. A new topology is proposed based on single-stage flyback converters. A 150-W constant-voltage flyback converter and a 50-W constant-current counterpart are respectively designed. The presented high-power LED streetlamp driver is thus implemented by combining these two converters with parallel-connected input and series-connected output. The operating principles of a flyback converter are firstly analyzed. Design guildlines for the controller and main circuit elements are provided. A prototype converter with 200-W rated output power and 0.7-A rated output current is realized. We proved the capability and good performance of this new topology.
[1] http://emis.erl.itri.org.tw。
[2] “高亮度發光二極體市場發展趨勢與展望”,工研院產業經濟與趨勢研究中心,2004年。
[3] 曾冠綺,「高效能多組並聯LED驅動電源研製」,國立台灣科技大學電子工程系碩士論文,2008年。
[4] 拓撲產業研究所,「2007深入剖析LED產業市場發展」,拓撲科技股份有限公司,2007年。
[5] 黃素琴、鄭名山,「LED道路照明產品應用」,經濟部能源報導,2011年5月。
[6] 陳揚斌,「高效率LLC同步整流串聯諧振轉換器之研製」,國立台灣科技大學電子工程系碩士論文,2009年。
[7] 鄭又元,「具功因修正器之雙開關準諧振返馳式轉換器研製」,國立台灣科技大學電子工程系碩士論文,2011年。
[8] 高益峰,「白光發光二極體 (LED)及照明產業」,中鼎月刊,331期。
[9] 莊賦祥,「藍綠光發二極體」,科學發展,394期,2001。
[10] 許招庸,「現代照明實務」,全華科技圖書股份有限公司,1998。
[11] 宋自恆、林慶仁,「功率因數修正器之原理與常用元件規格」,新電子科技雜誌217期,2004年4月。
[12] 李宗磐,「1.5 KW伺服器前級電源功率因數修正之系統性能分析與改善」,國立交通大學電機與控制工程學系碩士論文,2008年。
[13] 陳冠廷,「具功率因數修正器關閉功能之雙模式返馳式轉換器研製」,2010年。
[14] Abraham I. Pressman, Switching Power Supply Design, Third Edition, 2009.
[15] 黃維德,「用於LED驅動之單級返馳式PFC與雙級升壓-返馳式轉換器實現」,2012年。
[16] 蘇俊傑,「高效率200 W LED路燈驅動電源研製」,2011年。
[17] 梁適安,「交換式電源供給器之理論與實務設計」,2008年。
[18] ST Microelectronics, “L6561, Enhanced Transition Mode Power Factor Corrector, ” Application Note, AN966, 2003.
[19] 顏至良,「主僕式準諧振返馳式轉換器」,國立台灣科技大學電子工程學系碩士論文,2008年。
[20] 顏上進,「生化儀器用電源供應器之研製」,國立台灣科技大學研究所碩士論文,民國91年。
[21] Texas Instruments Inc, “UC3842 Current Mode PWM Controller ”Data Sheet, June 2007.
[22] Texas Instruments Inc, “LM358-DUAL OPERATIONAL AMPLIFIERS,” Datasheet, 2004
[23] ST Microelectronics, “Design Equations of High-power-factor Flyback Converter Based on the L6561,” Application Note, AN1059, 2003.
[24] 謝沐田,「高低頻變壓器設計」,全華圖書股份有限公司,10月2008年。
[25] IEC61000-3-2, “Electromagnetic compatibility (EMC) , Part3: Limits Section 2: Limits for harmonic currentemissions”, 1995.