研究生: |
潘力誌 Li-Chih Pan |
---|---|
論文名稱: |
鉛心橡膠支承墊多軸向遲滯行為之試驗與分析研究 Experimental and Analytical Study on Multiaxial Hysteresis Behavior of Lead Rubber Bearings |
指導教授: |
黃震興
Jenn-Shin Hwang |
口試委員: |
邱建國
Chien-Kuo Chiu 汪向榮 Shiang-Jung Wang |
學位類別: |
碩士 Master |
系所名稱: |
工程學院 - 營建工程系 Department of Civil and Construction Engineering |
論文出版年: | 2016 |
畢業學年度: | 104 |
語文別: | 中文 |
論文頁數: | 230 |
中文關鍵詞: | 鉛心橡膠隔震支承墊 、扭轉耦合效應 、多軸向遲滯行為 、非比例平面軌跡載重 、數學分析模型 |
外文關鍵詞: | lead-rubber bearing, multiaxial hysteresis behavior, non-porportional bilateral loading, mathematical model, torsional coupling effect |
相關次數: | 點閱:452 下載:12 |
分享至: |
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
在鉛心橡膠支承墊分析模型研究發展中,多數研究仍探討其受不同形式水平單軸向加載下之行為,而本研究為探討鉛心橡膠支承墊於垂直軸壓下,受雙軸向非比例平面軌跡載重下之行為,利用圓形與正方形之平面軌跡加載,探討扭轉耦合效應對於不同平面軌跡下支承墊有效勁度、等效阻尼比以及遲滯行為,並進行模擬雙軸向非比例平面軌跡載重下之遲滯行為,故本研究以三維材料組合定律為基礎,將水平單軸向數學分析模型延伸至雙軸數學分析模型,並藉由雙軸向非比例平面軌跡加載試驗結果與數學分析模型之比較,以驗證延伸後雙軸數學分析模型之適用性,進而提升數學分析模型應用於模擬鉛心橡膠支承墊遲滯行為之準確性。此外,根據試驗結果顯示,鉛心橡膠支承墊在經過多次振動台試驗後,其遲滯消能能力明顯降低,故本研究建議於實務應用上,為充分瞭解鉛心橡膠承墊於地震後之力學行為,應抽出一組隔震支承墊進行性能試驗,以驗證其是否還保有原始設計功能。
In existing study for hysteresis behavior of lead-rubber bearings (LRB), the bearings have been typically subjected to cyclic unilateral loading. In this study, non-proportional loading paths including circular orbit and square orbit is schemed to investigate the cyclic hysteresis of the bearing. Through the comparison between the results under different test conditions, the torsional coupling effect induced by non-proportional loading paths is less significant compared with that to high damping rubber bearings (HDRB) on bearing hysteresis behavior.
Three constitutive models implemented with the plane vector concept are employed to correlate the analytical results with the experimental results. With the decent agreement between the measurement and simulation, it is concluded that the extended mathematical model is more accurate and applicable for capturing the bilateral hysteresis behavior of LRB. In addition, hysteresis dissipation capacity of LRB is obviously decayed after several shaking table tests.
【1】 羅俊雄,“九二一集集大地震全面勘災精簡報告”,國家地震工程研究中心研究報告,NCREE-99-033,民國八十八年。
【2】 內政部營建署,“建築物耐震設計規範及解說”民國一百年七月。
【3】 Guide Specilcations for Seismic Isolation Design. American Association of State Highway and Transportation Officials,Washington, DC, 1999.
【4】 Manual for Menshin Design of Highway Bridges. Public Works Research Institute, Ministry of Construction of Japan, Tsukuba City, 1991.
【5】 SAP2000. Computer and Structures, Inc., Berkeley, California, USA
【6】 ETABS. Computer and Structures, Inc., Berkeley, California, USA
【7】 Abe M, Yoshida J, Fujino Y. Multiaxial Behaviors of Laminated Rubber Bearings and Their Modeling. I: Experimental Study. Journal of Structural Engineering 2004; 130(8): 1119-1132.
【8】 Abe M, Yoshida J, Fujino Y. Multiaxial Behaviors of Laminated Rubber Bearings and Their Modeling. II: Modeling. Journal of Structural Engineering 2004; 130(8): 1133-1144.
【9】 Ö zdemir, H. (1973). “Nonlinear transient dynamic analysis of yielding
structures.” PhD dissertation, University of California, Berkeley,Berkeley, Calif.
【10】 Graesser, E.J., and Cozzarelli, F.A. (1989). “Multidimensional model
of hysteretic material behavior for vibration analysis of shape memory
energy absorbing devices. Technical Rep.NCEER-89-0018.State University of New York at Buffalo, Buffalo, N.Y.
【11】 Hwang JS, Wu JD, Pan TC, Yang G., “ A Mathematical Hysteretic 42
Model for Elastomeric Isolation Bearing.”Earthquake Engineering and Structural Dynamics, 31(4),2002, pp.771-789.
【12】 江衍弘,“高阻尼橡膠隔震支承墊之分析模型修訂與驗證試驗研究”,碩士論文,國立台灣科技大學,2014。
【13】 黃柏文,“高阻尼橡膠隔震支承墊多軸向遲滯行為之試驗與分析研究”, 碩士論文,國立台灣科技大學,2015。
【14】 R. Bouc, “Force vibration of mechanical systems with hysteresis,” Abstract. Proc. 4th conf. on nonlinear oscillation, Prague,Czechoslovakia, 1967.
【15】 Y. K. Wen, “Method of random vibration of hysteretic systems,” J. Eng.Mech-ASCE, Vol. 102, p. 249, 1976.
【16】 許丁友,“LRB 隔震房屋結構之三軸向地震力試驗研究”,碩士論文,國立台灣科技大學,1999。
【17】 Skinner, R. I., Robinson, W. H. and McVerry, G. H., “ Seismic isolation in New Zealand. ” Nuclear Engineering and Design,127,p281-89,1991.
【18】 林育祺,“鉛心橡膠支承墊之擬靜態與動態遲滯特性”,碩士論文,國立台灣科技大學,1997。
【19】 Moss, P. J., Carr, A. J.and Cooke, N. (1996).“The Seismic Behavior
of Elastomeric and Lead-Rubber Bearings” 11th World Conference on Earthquake Engineering, 1692
【20】 郭文吉,“使用鉛心橡膠支承墊之隔震橋面版振動台試驗”,碩士論文,國立台灣科技大學,1996。
【21】 Koh, C. G., and Kelly, J. M. (1989). ‘‘Viscoelastic stability model for elastomeric isolation bearings.’’ J. Struct. Engrg., ASCE, 115(2), 285–
302
43
【22】 Haringx, J. A. (1948). ‘‘On highly compressible helical springs and
rubber rods and their application for vibration-free mountings. I.’’Philips Res.Rep., 3, 401–449.
【23】 Haringx, J. A. (1949a). ‘‘On highly compressible helical springs and
rubber rods and their application for vibration-free mountings.II.’’Philips Res. Rep., 4, 49–80.
【24】 Haringx, J. A. (1949b). ‘‘On highly compressible helical springs and
rubber rods and their application for vibration-free mountings.III.’’Philips Res. Rep., 4, 206–220.
【25】 Ryan, K. L., Kelly, J. M. and Chopra, A. K. (2004). ‘‘Experimental
observation of axial effects in isolation bearings.’’ 13th World Conference on Earthquake Engineering, 1707
【26】 Moussa, L., Ali, Z. Abdelkader, B. and Rahman, M. (2014).‘‘Nonlinear model for Lead Rubber Bearings including axial load effects and large deformations.’’ International Journal of Civil and Structural Engineering. 1 (3): pp. 173-176.
【27】 Conversy, F.(no title), Memoire, Anales des Ponts et Chaussies,Vol.4,
1967.
【28】 Masashi Yamamoto, Shigeo Minewaki, Naoto Kamoshita, Masaru Kikuchi, Ken Ishii,Osamu, Kouchiyama, Takahito Nakamura,‘‘Behaviors of a Sliding Rubber Bearing under Horizontal Bidirectional Loadings”, Proceeding of the15thWorld Conference on Earthquake Engineering, 2012.
【29】 Madsen, K., Nielsen, H.B., and Tingleff, O., Method for Non-linear
Least squares Problems, 2?? ed., Informatics and Mathematical Modeling, Technical University of Denmark, 2004.
【30】 Kelley, C.T., Iterative Methods for Optimization, SIAM, Frontiers in
44 Applied Mathematics 18, 1999.
【31】 Press, H. W., Flannery, B. P., Teukolsky, S. A., and Vetterling, T. W.(1988). “Numerical recipes in C”, Cambridge University Press,London.
【32】 Takahito Nakamura, Osamu Kouchiyama, Masaru Kikuchi,“Behaviors of lead rubber bearing under horizontal bi-directional loading test”, roceeding of the15thWorld Conference on Earthquake Engineering, 2012.