研究生: |
楊宗翰 Tuzng-Hang Yang |
---|---|
論文名稱: |
具順向能量回復相移式全橋升壓轉換器之分析與研製 Analysis and Implementation of a Phase-Shift Full-Bridge Step-up Converter with Energy Reverse Recovery |
指導教授: |
謝冠群
Guan-chyun Hsieh 柳宗禹 Tzong Yeu Leou |
口試委員: |
梁從主
Tsorng-Juu Liang 鄒應嶼 Ying Yu Tzou 陳德玉 Dan Chen |
學位類別: |
碩士 Master |
系所名稱: |
電資學院 - 電子工程系 Department of Electronic and Computer Engineering |
論文出版年: | 2007 |
畢業學年度: | 95 |
語文別: | 中文 |
論文頁數: | 80 |
中文關鍵詞: | 相移式全橋轉換器 、零電壓切換脈波寬調變 、順向回復能量 |
外文關鍵詞: | forward recovery energy, ZVS-PWM, Phase-shift full-bridge converter |
相關次數: | 點閱:278 下載:1 |
分享至: |
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本論文提出具順向能量相移式全橋升壓轉換器,轉換器採用相移式全橋(Phase-Shifted Full-Bridge)轉換架構採用零電壓切換脈波寬調變(ZVS-PWM)方式來驅動。轉換器共有五個轉換狀態,能量功率傳送狀態、第一次諧振狀態、能量保持狀態、第二次諧振狀態及轉向狀態等,均有詳盡的推導及模型化。利用諧振電感的輔助繞組建立順向回復能量轉移至負載可降低諧振振鈴和增加效率。本文對整個系統建立起小信號模型及轉移函數分析,且提供完整的設計考量和設計步驟。
最後實際設計製作一部輸入電壓48V、輸出電壓為250V、輸出功率為600W的實例,且完成特性規量格測(η=80%)及開迴路系統的模擬(Isspice)驗證。
關鍵字:相移式全橋轉換器,零電壓切換脈波寬調變,順向回復能量
Abstract
This thesis presents a phase-shift full-bridge step-up converter. An H-diagonal full-bridge structure driven by ZVS-PWM is proposed. The converter has five conversion states that include power-deliver state, first-resonant state, energy-holding state, second-resonant state, and commutation state. An auxiliary winding around resonant inductor is built to transfer the forward recovery energy to load so as to reduce the resonant ringing and increase efficiency. Small signal analysis and design consideration are conducted to verify the system performance and set up system design, respectively.
A practical design of 600W step-up power converter with 250V output is examined. Complete system design, simulation, and realization are proceeded to investigate the system performance. The converter can operate with ZVS and can provide high efficiency up to 80%. Simulation and experimentation are so close to the theoretical prediction.
Keyword:Phase-shift full-bridge converter, ZVS-PWM, forward recovery energy
參 考 文 獻
[1] F. C. Lee, “High-Frequency Quasi-Resonant, and Multi-Resonant Converter Technologies,” in Proc. IEEE IECON’88, pp. 509-521, 1988.
[2] G. Hua and F. C. Lee, “Soft-Switching PWM Techniques and Their Applications,” in Proc. EPE’93, pp. 87-92, 1993.
[3] V. Vlatkovic, J. A. Savatc, R. B. Ridley, F. C. Lee, and B. H. Cho, “Small-Signal Analysis of the Phase-Shifted PWM Converter,” in IEEE Trans. Power Electronics, vol. 7, no. 1, pp. 28-35, Jan. 1992.
[4] G. C. Hsieh, S. H. Tzeng, and J. C. Chuang, "Realization study of medium-power module AC/DC converter by zero-voltage-switching PWM technique," Proc. IEEE 1997 Int. Conf. Power Electron. Drive Syst. (PEDS'97), Singapore, vol. 1, pp. 235-245, 1997.
[5] B. Andreycak, “Phase Shifed Zero Voltage Transition Design Considerations and the UC3875 PWM Controller,“ in Unitrode U-136A’97, pp. 1-15, 1997.
[6] L. Balogh, ”The New UC3879 Phase-Shifted PWM Controller Simplifies the Design of Zero Voltage Transition Full Bridge Converters,” in Unitrode U-154’99, pp. 1-8, 1999.
[7] H. Hino, T. Hatakeyama, M. Nakaoka, “Resonant PWM Inverter Linked DC-DC Converter Using Parasitic Impedances of High-Voltage Transformer and Its Applications to X-Ray Generator,” in Proc. IEEE PESC’88 , pp. 1212-1219, 1988.
[8] V. Garcia, M. Rico, J. Sebastian, M.M. Hernando, and J. Uceda, ”Study of an optimized resonant converter for high-voltage applications,” in CIEP'94, pp. 114 –121, 1994.
[9] J. A. Sabate, V. Vlatkovic, R. B. Ridley, F. C. Lee, and B. H. Cho, “Design Considerations for High Voltage High Power Full Bridge Zero Voltage Switched PWM Converter,” in Proc. IEEE APEC’90, pp. 275-284, 1990.
[10] L. Zhu, “A Novel Soft-Communtating Isolated Boost Full-Bridge ZVS-PWM DC-DC Converter for Bidirectional High Power Applications,” IEEE Trans. on power electronics, vol. 21, no.2, pp. 422-429, March. 2006.
[11] L. R. Lewis, B. H. Cho, B. A. Carpenter, and F. C. Lee, “Modeling, analysis and design of distributed power systems,” in Proc. IEEE PESC’89, pp. 152-159, 1989.
[12] K. Siri, C. Q. Lee, and T. F. Wu, “Current Distribution control for Parallel Connected Connected Converters:Part2,” IEEE Trans. on AES, vol. 28, July 1992.
[13] C. Cuardos, C. Y. Lin, D. Boroyevich, R. Watson G. Skutt F. C. Lee , and P. Ribardiere, “Design procedure and Modeling of High Power, High Performance, Zero-Voltage Zero-Current Switched, Full-Bridge PWM Converter,” in Proc. IEEE APEC’97, pp. 790-798, 1997.
[14] G. C. Hsieh, J. C. Li , and M. H. Liaw, “A Study on Full-Bridge Zero-Voltage-Switched PWM Converter: Design and Experimentation,” in Proc. IEEE IECON’93, pp. 1281-1285, 1993.
[15] J. A. Sabate, V. Vlatkovic, R. B. Ridley, F. C. Lee, and B. H. Cho, “Design Considerations for High Voltage High Power Full Bridge Zero Voltage Switched PWM Converter,” in Proc. IEEE APEC’90, pp. 275-284, 1990.
[16] V. Vorperian, R. Tymerski, and F. C. Y. Lee, “Equivalent Circuit Models for Resonant and PWM Switches,” IEEE Trans. Power Electronics, vol. 4, no. 2, pp. 205-214, Apr. 1989.
[17] 劉翼德,「高電壓輸出之零電壓切換相移式全橋升壓型轉換器的分析及研製」,台灣科技大學碩士論文,民國九十三年。