研究生: |
許博凱 Po-Kai,Hsu - - |
---|---|
論文名稱: |
無偵察電源電壓之平均電流模式控制功率因數修正器研製 Study and Implementation of an Average Current Mode Control Power Factor Corrector without Voltage Sensing |
指導教授: |
楊宗銘
Chung-Ming Young |
口試委員: |
劉益華
Yi-Hua Liu 謝耀慶 Yao-Ching Hsieh |
學位類別: |
碩士 Master |
系所名稱: |
電資學院 - 電機工程系 Department of Electrical Engineering |
論文出版年: | 2017 |
畢業學年度: | 105 |
語文別: | 中文 |
論文頁數: | 50 |
中文關鍵詞: | 昇壓式轉換器 、無輸入電壓偵察 、主動式功因修正 、平均電流模式控制 |
外文關鍵詞: | boost converter, without input voltage sensing, active power factor correction, average current mode control |
相關次數: | 點閱:283 下載:2 |
分享至: |
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本論文之目的在研製一升壓型功率因數修正器,針對一般需要擷取輸入電壓為參考訊號的控制器中有乘法器之缺點,使用一種無需電源電壓偵察之平均電流模式控制的IC作為控制核心,並分析其操作原理及與單週期、平均電流模式控制法做比較。本文利用德州儀器公司所產的UCC28019為控制器,驗證功率因數修正器在實作及設計分析上是否正確。本文所研製的詳細規格包含輸入電壓為90~264Vrms/60Hz,輸出電壓為400Vdc,最大功率為460W,切換頻率操作在65kHz。經實驗結果證實,在滿載情況下,效率可達93%、功率因數可達0.99以上。此外,電流總諧波失真在7.5%以下,輸入電流諧波亦可滿足IEC 61000-3-2 Class-D之規範。由以上結果驗證設計與實驗的正確性。
The objective of this thesis is to design and implement a boost type power factor corrector (PFC).Preventing the shortcoming of sensing the input voltage, the proposed method using an average current mode control without supply voltage sensing. This thesis employs a commercial PFC IC as the controller and analyzes the operating principle of the proposed converter. Comparisons between the proposed method and one-cycle control method both with average current mode control are made in this thesis as well. The power factor controller, UCC28019, is used as the controller to implement and verify the performance of the proposed method. The specifications of the proposed PFC are as follow: input voltage range 90~264 Vrms/60 Hz, output voltage 400 Vdc , rated output power 460 W, and the switching frequency 65 kHz. Experimental results show that the efficiency is up to 93%, power factor is greater than 0.99, the THD of the input current is less than 7.5%, and the current harmonics can comply with the IEC 61000-3-2 Class D regulation under the full load conditions. These results confirm the design and implementation.
[1]J. Rajagopalan, F. C. Lee, and P. Nora, “A general technique for derivation of average current mode control laws for single- phase power-factor-correction circuits without input voltage sensing, ” IEEE Trans.Power Electron., Vol. 14, no. 4, pp. 663-672 Jul. 1999.
[2] A. Abramovitz, M. Evzelman, S. Beb-Yaakov, “Investigation of an alternative APFC control with no sensing of line voltage based on a triangular modulation carrier”, Proc. IEEE Appl. Power Electron. Conf., pp. 709-714, 2008.
[3] S. Ben-Yaakov, I. Zeltser, “The dynamics of a PWM boost converter with resistive input”, Industrial Electronics IEEE Transactions on, vol. 46, pp. 613-619, 1999.
[4] A. Abramovitz “Steady-state characteristics of the off-duty cycle controlled APFC with no input voltage sensing ” in 29th Int. Telecommunications Energy Conf. (INTELEC) Rome Italy 2007 pp. 541-546.
[5]梁適安譯,「高頻交換式電源供應器原理與設計」,二版,全華科技圖書,1995。
[6]梁適安,「交換式電源供應器理論與實務設計」,全華科技圖書,2004。
[7]葉孝益,「切換式電源供應系統功因控制分析與研究」,碩士,動力機械系,國立清華大學,2003。
[8]R. Carbone and P. Corsonello, “A new passive power factor corrector for single-phase bridge diode rectifier,” in proc. IEEE PESC’03, pp. 701-706,Jun. 2003.
[9]J. Zhang, M. M. Jovanovic, and F. C. Lee, “Comparison between CCM single- stage and two-stage boost PFC converters,” in Proc. IEEE Applied Power Electron. Conf., pp. 335-341, Mar. 1999.
[10]L. Rossetto, G. Spiazzi, and P. Tenti, “Control techniques for power factor correction converters,”in Proc. PEMC’94, pp. 1310-1318, Sep. 1994.
[11]Z. Yang and P. C. Sen, “A novel technique to achieve unity power factorand fast transient response in AC-to-DC converters,” IEEE Trans. PowerElectron., vol. 16, no. 6, pp. 764-775, Nov. 2001.
[12]陳星兆,「基於Cockcroft-Walton倍壓電路具功率因數修正之柔性切換高升壓比交流-直流轉換器」,碩士,電機工程系,國立台灣科技大學,2013。
[13] C. S. Silva, Power factor correction with the UC3854, Unitrode.
[14] T. Yoshida, O. Shiizuka, O. Miyashita and K. Ohniwa,“An Improvement Technique for the Efficiency of High-Frequency Switch-Mode Rectifiers,”IEEE Trans. on Elec., vol. 15, no. 6, pp. 1118-1123, Nov. 2000.Norwell,Mass.: Kluwer Academic, 2001.
[15]江建成,「單級功因修正返馳式電源轉換器之製作」,碩士,電機工程系, 國立中山大學,2007。
[16] J.-C. Tsai, C.-L. Chen, Y.-H. Lee, H.-Y. Yang, M.-S. Hsu, and K.-H. Chen, “Modified hysteretic current control (MHCC) for improving transient response of boost converter,” IEEE Trans. Circuits Syst. I, Reg.Papers, vol. 58, no. 8, pp. 1967–1979, Aug. 2011.
[17] R. Redl and B. P. Erisman, “Reducing distortion in peak-current-controlled boost power-factor correctors,” IEEE Applied Power Electronics Conference and Exposition, vol. 2, pp. 576-583, Feb. 1994.
[18] K.M. Smedley and S.Cuk, “One-cycle control of switching converters” IEEE Trans. Power Electron., vol. 10, Issue 6, pp. 625-633,Nov 1995.
[19] Z. Lai & K.M. Smedley “A New Extension of One-Cycle Control and Its Application to Switching Power Amplifiers” IEEE Transactions on Power Electronics Volume: 11, Issue: 1, Jan 1996.
[20]K.M. Smedley and S.Cuk, “Dynamics of one-cycle controlled Cuk converters”IEEE Trans. Power Electron., vol. 10,Issue:6, pp. 634-639,Nov 1995.
[21]張家榮,「不需輸入電壓感測之主動型功因修正AC/DC 轉換器的研製」, 碩士,電機工程系,國立中山大學,2006。
[22]Texas Instruments Inc., “UCC28019A, continuous conduction mode power factor corrector,” Data Sheet, 2015.
[23]昌星CM467160 Datasheet
[24]“Zero Recovery Rectifier SiC Schottky Diode CSD10060,” datasheet, Cree.
[25] Power supply HOLD-UP time - STMicroelectronics
[26] Texas Instruments Inc.,“UCC28019A 8-Pin Continuous Conduction Mode (CCM) PFC Controller,” Data Sheet, 2015.
[27] R. Brown and M. Soldano“One Cycle Control IC Simplifies PFC Designs”,IEEE Applied Power Electronics Conference, 2005, pp. 825- 829.