簡易檢索 / 詳目顯示

研究生: 童健俊
Jian-Jun Tong
論文名稱: 改良型單級高穩壓率多組輸出雙晶順向式轉換器
Study and Implementation of an Improved Single-stage High-regulation Multi-output Dual-switch Forward Converter
指導教授: 羅有綱
Yu-Kang Lo
邱煌仁
Huang-Jen Chiu
口試委員: 林景源
Jing-Yuan Lin
林忠義
none
學位類別: 碩士
Master
系所名稱: 電資學院 - 電子工程系
Department of Electronic and Computer Engineering
論文出版年: 2013
畢業學年度: 101
語文別: 中文
論文頁數: 82
中文關鍵詞: 順向式轉換器
外文關鍵詞: Forward
相關次數: 點閱:181下載:7
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 本論文主要研製一台具高穩壓率之多組輸出的直流-直流轉換器,採用主架構為改良型雙晶順向式轉換器,利用額外洩磁繞組技術改善傳統雙晶順向式轉換器責任週期無法超過50%之缺點,使其整體轉換效率提升。每組輸出以雙向開關取代順向整流二極體,並且各自回授穩壓,再將回授信號合成後控制一次側開關,使單級轉換也可達到高穩壓特性。
    文中針對提出的架構進行電路分析,導出設計流程,做為選擇適當元件的依據,且使用Simplis模擬軟體完成整機之電路模擬,最後實現一台總輸出功率250W,具有三組輸出分別為12V/15A、5V/10A、3.3V/6A之直流轉換電路,並以實測的結果驗證模擬和理論。


    This thesis mainly studies and implements a multi-output DC-DC converter with high regulation rate. Dual-switch forward converter is adopted for the main structure. With extra windings to release energy, the efficiency and inherent limitation of duty cycle within 50% can be improved. The forward rectifiers will be replaced with AC-switch in each output which voltage will be using regulated, individually. Then the feedback signal will be combine to control the primary side switch. Achieve high regulator rate using a single-stage conversion.
    According to the proposed circuit analyses and design process, use Simplis simulation software as the basis for selecting the appropriate components to implement the circuit simulation, and finally implement a total output power of 250W triple output to 12V/15A, 5V/10A 3.3V/6A DC conversion circuit, and the measured results verify the simulation and theory.

    摘 要i Abstractii 誌 謝iii 目 錄iv 圖索引vii 表索引viii 第一章 緒論9 1.1研究動機及目的9 1.2研究內容10 1.3論文大綱11 第二章 傳統多組輸出順向式轉換器分析12 2.1順向式轉換器架構12 2.1.1傳統順向式轉換器架構12 2.1.2傳統雙晶順向式轉換器16 2.1.3優缺點比較20 2.2傳統多組輸出電路實現方法21 2.2.1權重比回授21 2.2.2串接降壓型轉換器22 2.2.3優缺點比較23 第三章 改良型多組輸出雙晶順向轉換器24 3.1基本工作原理24 3.2電路穩態分析31 3.3一次側工作信號的控制方式40 3.4雙向開關控制信號設計考量及動作分析43 3.4.1 Q331延遲截止動作43 3.4.2 Q331延遲截止設計方法46 3.4.3 Q332延遲導通動作47 3.4.4 Q332延遲導通設計方法48 第四章 電路設計與製作50 4.1電路規格50 4.2變壓器設計51 4.2.1鐵芯選擇51 4.2.2一、二次側繞組圈數設計51 4.2.3一、二次側繞組線徑設計53 4.2.4洩磁繞組線徑設計53 4.3開關晶體選擇54 4.4控制IC介紹55 4.5輸出濾波穩壓元件設計59 4.5.1輸出濾波電感設計59 4.5.2輸出穩壓電容設計59 第五章 實驗模擬及實測波形數據61 5.1電路實驗模擬61 5.1.1模擬電路圖61 5.1.2模擬實驗波形圖63 5.2電路實驗量測66 5.2.1測試儀器及條件66 5.2.2實驗波形圖67 5.3電路轉換效率及電壓變化量測72 第六章 結論與未來展望77 6.1結論77 6.2未來展望78 參考文獻80

    [1]梁適安,交換式電源供應器之理論與實務設計,全華科技圖書出版,民國98年8月。
    [2]顏上進,LLC電源設計與分析,國立台灣科技大學電子工程系研究所碩士論文,民國95年。
    [3]R. Elferich, T. Duerbaum, “A New Load Resonant Dual Output Converter,” IEEE PESC, pp.1319-1324, 2002.
    [4]B. Yang, “Topology Investigation for Front End DC/DC Power Conversion for Distributed Power,” 2003
    [5]董育豪,儀器用低穩壓率輔助電源設計,國立台灣科技大學電子工程系研究所碩士論文,民國101年。
    [6]ANPEC Electronics Corporation, “Synchronous Buck PWM Controller,” Data Sheet, Apr. 2006.
    [7]Texas Instruments Inc, “5.5-V to 36-V, 3-A Step-Down Swift Converter,” Data Sheet, 2006.
    [8]Texas Instruments Inc, “Using the TPS5430 As An Inverting Buck Boost Converter,” Application Report, 2007.
    [9]N. Mohan, T. M. Undeland, W. P. Robbins, “Power electronics: Converter, Applications, and Design, Third Edition,” John Wiley&Sons, Inc., 2002.
    [10]Abraham I. Pressman, “Switching Power Supply Design, Third Edition,” McGraw-Hill Companies Inc., 2009.
    [11]Muhammad H. Rashid, “Power electronics: circuits, devices, and applications, Third Edition,” Prentice Hall, 2003.
    [12]賴怡臻,具倍流整流之雙晶順向-返馳式轉換器,國立台灣科技大學電子工程系研究所碩士論文,民國100年。
    [13]H. E. Tacca, “Single-switch two- output flyback-forward converter operation,” IEEE trans. on Power Electronics, Vol.13, No.5, Sept. 1998, pp. 903-911.
    [14]Kusuhara Yoshito, Ninomiya Tamotsu and Nakagawa Shin, “Steady-State Analysis of a Novel Forward-Flyback-Mixed Converter,” Power Electronics and Motion Control Conference, 2006. EPE-PEMC 2006. 12th International , vol., no., pp.60-65, Aug. 30 2006-Sept. 1 2006.
    [15]Kusuhara Yoshito, Ninomiya Tamotsu and Nakagawa Shin, “Complete analysis of steady-state and efficiency considerations in a Forward-Flyback Mixed Converter,” Power Electronics, 2007. ICPE '07. 7th Internatonal Conference on , vol., no., pp.620-624, 22-26 Oct. 2007.
    [16]Himmelstoss F.A., Votzi H.L., “Comparison of a new combined four-diode forward-flyback converter with the classical forward converter,” Signals, Circuits and Systems, 2009. ISSCS 2009. International Symposium on , vol., no., pp.1-4, 9-10 July 2009.
    [17]Huber L., Jovanovic M.H., “Forward-flyback converter with current-doubler rectifier: analysis, design, and evaluation results,” Power Electronics, IEEE Transactions on , vol.14, no.1, pp.184-192, Jan 1999.
    [18]D. W. Hart 著,王順忠譯,電力電子學,東華書局,民國87年。
    [19]G. C. Chryssis 著,梁適安譯,高頻交換式電源供應器,台北:全華圖書股份有限公司,民國84年。
    [20]謝沐田,低頻變壓器設計,全華科技圖書出版,民國97年10月。
    [21]何此昂,周渡海,變壓器與電感器設計方法及應用實例,人民郵電出版社,民國100年2月。
    [22]Texas Instruments, “TL494, Pulse Width Modulation Control Circuits,” Data Sheet, 2005.
    [23]Texas Instruments, “Designing Switching Voltage Regulators With the TL494,” Application Notes, SLVA001E, 2008.

    無法下載圖示 全文公開日期 2016/01/30 (校內網路)
    全文公開日期 本全文未授權公開 (校外網路)
    全文公開日期 本全文未授權公開 (國家圖書館:臺灣博碩士論文系統)
    QR CODE