簡易檢索 / 詳目顯示

研究生: 曾逸民
Yi-Min Tzeng
論文名稱: 基於主動雙橋式轉換器相移調變控制之固態變壓器
A Solid-State Transformer Implemented by Phase-Shift Modulated Dual-Active-Bridge Converter
指導教授: 邱煌仁
Huang-Jen Chiu
謝耀慶
Yao-Ching Hsieh
口試委員: 邱煌仁
Huang-Jen Chiu
林景源
Jing-Yuan Lin 
黃仁宏
Peter J. Huang
謝耀慶
Yao-Ching Hsieh
學位類別: 碩士
Master
系所名稱: 電資學院 - 電子工程系
Department of Electronic and Computer Engineering
論文出版年: 2018
畢業學年度: 106
語文別: 中文
論文頁數: 91
中文關鍵詞: 固態變壓器交流-交流主動雙橋式轉換器相移控制
外文關鍵詞: Solid-State Transformer, AC-AC Dual active bridge converter, Phase shift modulation
相關次數: 點閱:205下載:4
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 本論文主旨為採用主動雙橋式轉換器架構,以研製一固態變壓器。傳統變壓器由於操作於低頻電壓,有體積大、重量重等問題,在應用上會受到許多限制,故需要發展新技術來取代。
    本論文實際完成一台輸入電壓為最大300 Vrms、輸出電壓最大為300 Vrms以及輸出功率5 kW,的交流-交流固態變壓器。功率電路主要包含一主動雙橋式轉換器,藉由鎖相迴路提取輸入電壓值做為控制器穩定輸出電壓的參考命令,用以實現匝比為一的變壓器功能,並以數位訊號處理器來實現數位閉迴路控制。經由實驗結果顯示再分別不同電壓輸入情況下,固態變壓器都能有效地穩定輸出電壓等於相對應的輸入電壓,且在不同的負載下效率均在92%以上。


    The main purpose of this paper is to develop a solid-state transformer using an active dual-bridge converter architecture. Conventional transformers have many problems due to their operation in low-frequency voltages, such as large size and heavy weight. Therefore, new transformers need to be developed to replace them.
    In this paper, an AC-AC solid-state transformer with an input voltage of 300 Vrms maximum, an output voltage of 300 Vrms and an output power of 5 kW is actually completed. The power circuit mainly includes an active double-bridge converter, and the input voltage value is detected by the phase-locked loop as a reference command for the controller to stabilize the output voltage, and the transformer function is realized by the digital signal processor. Realize digital closed loop control. The experimental results show that the solid-state transformer can effectively stabilize the output voltage equal to the corresponding input voltage under different voltage input conditions, and the efficiency is above 92% under different loads.

    目錄 摘 要 i Abstract ii 致謝 ii 圖索引 vii 表索引 xi 第一章 緒論 1 1.1 前言 1 1.2 研究動機與目的 2 1.3 論文內容架構 3 第二章 文獻回顧 4 2.1 傳統變壓器介紹 5 2.2 固態變壓器介紹 7 第三章 系統架構與動作分析 11 3.1 直流-直流主動雙橋式轉換器 12 3.2 直流-直流主動雙橋式轉換器原理分析 13 3.3 輸出電壓與相移角關係 19 3.4 交流-交流主動雙橋式轉換器 24 第四章 系統研製 27 4.1 電路規格 27 4.2 電路元件設計 27 4.2.1 漏感設計 28 4.2.2 功率開關元件 28 4.2.3 高頻變壓器 29 4.3 取樣電路 34 4.3.1 電壓極性判斷電路 34 4.3.2 電壓取樣電路 35 4.4 光纖訊號傳輸 35 第五章 控制系統設計 37 5.1 數位訊號處理器介紹[20,21] 38 5.1.1 TMS320F28035簡介 39 5.1.2 ePWM模組 41 5.2 控制器規劃與設計 45 5.2.1 韌體流程規劃 46 5.2.2 啟動與保護程序 48 5.2.3 數位鎖相迴路 50 5.2.4 輸出峰值電壓取樣 54 5.2.5 數位補償器 57 第六章 實驗結果分析 61 6.1 模擬結果 63 6.1.1 各電壓測試情況 63 6.1.2 變動電壓 66 6.2 實測結果 67 6.3 效率量測 69 第七章 結論與未來展望 71 7.1 結論 71 7.2 未來展望 72 參考文獻 73

    [1] J. H. Harlow, Electric power transformer engineering. Boca Raton: CRC press, 2007.
    [2] A. Q. Huang and J. Baliga, "FREEDM System: Role of power electronics and power semiconductors in developing an energy internet," 2009 21st International Symposium on Power Semiconductor Devices & IC's, Barcelona, 2009, pp. 9-12.
    [3] J. L. Brooks, Solid state transformer concept development, Naval Material Command. Port Hueneme, CA: Naval construction Battalion Center, 1980.
    [4] San Jose,“Proof of the principle of the solid-state transformer and the AC/AC switch mode regulator,” CA, EPRI TR, 1995.
    [5] K. Harada, F. Anan, K. Yamasaki, M. Jinno, Y. Kawata, T. Nakashima, K. Murata, and H. Sakamoto, “Intelligent transformer,” in Conf. Rec. IEEE PESC, 1996, pp. 1337-1341
    [6] X. She, A. Q. Huang and R. Burgos, "Review of Solid-State Transformer Technologies and Their Application in Power Distribution Systems," in IEEE Journal of Emerging and Selected Topics in Power Electronics, vol. 1, no. 3, pp. 186-198, Sept. 2013.
    [7] A. Abedini and T. Lipo, "A novel topology of solid state transformer," 2010 1st Power Electronic & Drive Systems & Technologies Conference (PEDSTC), Tehran, Iran, 2010, pp. 101-105.
    [8] K. K. Mohapatra and N. Mohan, “Matrix converter fed open-ended power electronic transformer for power system application,” in Proc. IEEE. Power and Energy general meeting, 2008, pp.1-6.
    [9] H. Mirmousa and M. R. Zolghadri, “A novel circuit topology for three-phase four-wire distribution electronic power transformer,” in Proc. IEEE. PEDS, 2007, pp.1215-1222.
    [10] A. J. Jin, H. T. Li, and S. L. Li, “A new matrix type three-phase four-wire power electronic transformer,” in Proc. IEEE. PESC., 2006, pp.1-6.
    [11] M. Sabahi, A. Y.Goharrizi, S. H.Hosseini, M. B. B. Sharifian, and G. B. Gharehpetian, “Flexible power electronic transformer,” IEEE Transactions on Power Electronics, vol. 25, no. 8, pp. 2159-2169, January 2010.
    [12] P. Drabek, Z. Peroutka, M. Pittermann, and M. Cedl, “New configuration of traction converter with medium frequency transformer using matrix converters,” IEEE Transactions on Industrial Electronics, vol. 58, no. 11, pp. 5041-5048, Nov. 2011.
    [13] M. R. Banaei and E. Salary, “Power quality improvement based on novel power electronic transformer,” in Proc. PEDSTC., 2011, pp.286-291.
    [14] M. Sabahi, S. H. Hosseini, M. B. Sharifian, A. Y. Goharrizi, and G. B. Gharehpetian, “Zero-voltage switching bi-directional power electronic transformer,” IET Power Electronics, vol. 3, no. 5, pp. 818-828, August 2010.
    [15] D. Grider, M. Das, A. Agarwal, J. Palmour, S. Leslie, J. Ostop, R. Raju, M. Schutten, and A. Hefner, “10kV/120A SiC DMOSFET Half-bridge Power Modules for 1MVA Solid State Power substation,” in Electric Ship Technologies Symposium,” 2011, pp.131-134.
    [16] K. Hatua, S. Dutta, A. Tripathi, S. Baek, G. Karimi, and S. Bhattacharya,“Transformer less intelligent power substation design with 15kV SiC IGBT for grid interconnection,” in Proc. IEEE IEEE Energy Conversion Congress and Exposition, 2011, pp. 4225-4232.
    [17] G. Ortiz, J. Biela, D. Bortis, and J. W. Kolar, “1 Megawatt, 20 kHz, isolated, bidirectional 12kV to 1.2kV DC-DC converter for renewable energy applications,” in Proc. Intel. IPEC, 2010, pp. 3212-3219.
    [18] H. F. Fan and H. Li, “High frequency transformer isolated bidirectional DC-DC converter modules with high efficiency over wide load range for 20kVA solid state transformer,” IEEE. Trans. Power. Electronic, vol. 26, no. 12, pp.3599-3608, Dec. 2011.
    [19] H. I. Eini and S. Farhangi, “Analysis and design of power electronic transformer for medium voltage levels,” in Proc. IEEE. PESC., 2006, pp. 1-5.
    [20] Texas Instruments Inc., “Piccolo™ Microcontrollers,” Datasheet, October 2013.
    [21] Texas Instruments Inc., “TMS320x2802x, 2803x Piccolo Enhanced Pulse Width Modulator (ePWM) Module,” Datasheet, March 2011.
    [22] S. Golestan, M. Monfared, F. D. Freijedo and J. M. Guerrero, "Design and Tuning of a Modified Power-Based PLL for Single-Phase Grid-Connected Power Conditioning Systems," in IEEE Transactions on Power Electronics, vol. 27, no. 8, pp. 3639-3650, Aug. 2012.
    [23] M. Ciobotaru, R. Teodorescu and F. Blaabjerg, "A new single-phase PLL structure based on second order generalized integrator," 2006 37th IEEE Power Electronics Specialists Conference, Jeju, 2006, pp. 1-6.
    [24] R. M. Santos Filho, P. F. Seixas, P. C. Cortizo, L. A. B. Torres and A. F. Souza, "Comparison of Three Single-Phase PLL Algorithms for UPS Applications," in IEEE Transactions on Industrial Electronics, vol. 55, no. 8, pp. 2923-2932, Aug. 2008.
    [25] D. Zhang, H. Li and E. G. Collins, "Digital Anti-Windup PI Controllers for Variable-Speed Motor Drives Using FPGA and Stochastic Theory," in IEEE Transactions on Power Electronics, vol. 21, no. 5, pp. 1496-1501, Sept. 2006.
    [26] Hwi-Beon Shin, "New antiwindup PI controller for variable-speed motor drives," in IEEE Transactions on Industrial Electronics, vol. 45, no. 3, pp. 445-450, Jun 1998.
    [27] Anirban Ghoshal and Vinod John,“Anti-windup Schemes for Proportional Integral and Proportional Resonant Controller”, in Notional Power Electronic Conference,2010.

    QR CODE