簡易檢索 / 詳目顯示

研究生: 許毓群
Yu-chun Hsu
論文名稱: 具功因校正之數位化直流電源供應器研製
Implementation of a Digital DC Power Supply with Power Factor Correction
指導教授: 劉添華
Tian-hua Liu
口試委員: 李永勳
Yuang-shung Lee
楊勝明
Sheng-ming Yang
黃仲欽
Jonq-chin Hwang
學位類別: 碩士
Master
系所名稱: 電資學院 - 電機工程系
Department of Electrical Engineering
論文出版年: 2008
畢業學年度: 96
語文別: 中文
論文頁數: 126
中文關鍵詞: 功因校正直流電源供應器數位訊號處理器
外文關鍵詞: power factor correction, DC power supply, digital signal processor
相關次數: 點閱:201下載:2
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報

本文研製一部具功因校正的數位化直流電源供應器,硬體電路主要包括功因校正電路及相移式全橋電路。文中以積體電路UC3854作為功因校正的控制器,並使用數位訊號處理器TMS320LF2407A完成閉迴路控制。本文中針對相關原理及設計方法進行探討。最後完成一部輸出直流48V,輸出功率864W,輸入電源側功率因數0.99,且輸入電流諧波滿足EN-61000-3-2規範的電源供應器。實測的結果與理論分析相當符合,說明本文的可行性及正確性。


The thesis implements a digital DC power supply with power factor correction. The hardware circuit includes a power factor correction circuit and a phase-shift full-bridge circuit. In the thesis, a UC3854 is used to control the power factor of the input source. In addition, a TMS320LF2407A is used to execute the closed loop control algorithms. The detailed principles and design methods are included. Finally, a DC power supply with 48V/864W, 0.99 power factor, satisfactory EN-61000-3-2 Standards is implemented. Experimental results can validate the theoretical analysis to show the feasibility and correctness of the thesis.

摘 要 I Abstract II 目錄 III 圖目錄 VI 表目錄 XI 符號索引 XII 第一章 緒論 1 1.1簡介 1 1.2文獻回顧 2 1.3內容大綱 4 第二章 系統介紹 5 2.1簡介 5 2.2系統架構 6 第三章 功因校正電路介紹 9 3.1簡介 9 3.2功率因數的定義 9 3.3功因校正的方法 12 3.4功因校正電路設計 19 3.4.1 基本原理 19 3.4.2 升壓型轉換器模式建立 21 3.4.3 功因校正電路模式建立 29 第四章 相移式全橋轉換器 33 4.1簡介 33 4.2電路架構 33 4.3工作原理 34 4.4小訊號模型建立 47 第五章 系統研製 54 5.1簡介 54 5.2功因校正電路設計 55 5.2.1 儲能電感設計 56 5.2.2 輸出電容設計 58 5.2.3 功率開關與輸出功率二極體設計 59 5.2.4 控制電路設計 60 5.2.4.1功率開關切換頻率設定 62 5.2.4.2檢知網路K1、K2、K3的設計 62 5.2.4.3前饋補償網路設計 65 5.2.4.4電壓控制器設計 67 5.2.4.5電流控制器設計 69 5.3 相移全橋轉換器電路設計 71 5.3.1 功率開關的選擇 72 5.3.2 高頻變壓器的設計 73 5.3.3 振盪箝制電路設計 76 5.3.4 諧振電感和阻隔電容設計 77 5.3.5 輸出整流濾波電路的設計 80 5.4回授電路設計 83 5.5驅動電路的設計 84 5.6輔助電源電路設計 85 第六章 數位訊號處理器 86 6.1簡介 86 6.2 軟體流程 89 6.2.1主程式 89 6.2.2 中斷服務副程式 92 6.2.3 相移控制實現方法 94 第七章 實測結果 96 7.1簡介 96 7.2實測結果 96 第八章 結論與建議 121 參考文獻 122 作者簡介 126

參考文獻
[1] N. Lakshminarasamma and V. Ramanarayanan, “A family of auxiliary switch ZVS-PWM DC-DC converters with coupled inductor,” IEEE Trans. Power Electron., vol. 22, no. 5, pp. 2008-2017, Sep. 2007.
[2] Y. S. Lee and G. T. Cheng, “Quasi-resonant zero-current-switching bidirectional converter for battery equalization applications,” IEEE Trans. Power Electron., vol. 21, no. 5, pp. 1213-1224, Sep. 2006.
[3] W. Tang, C. Shan, and F. C. Lee, “Charge control for zero-voltage-switching multiresonant converter,” IEEE Trans. Power Electron., vol. 11, no. 2, pp. 270-274, Mar. 1996.
[4] T. F. Wu, S. A. Liang, and Y. K. Chen, “A structural approach to synthesizing soft switching PWM converters,” IEEE Trans. Power Electron., vol. 18, no. 1, pp. 38-43, Jan. 2003.
[5] C. M. Wang, “A novel single-stage series-resonant buck-boost inverter,” IEEE Trans. Ind. Electron., vol. 52, no. 4, pp. 1099-1108, Aug. 2005.
[6] H. Chen, E. K. Kenneth, and K. J. Tseng, “Generalized optimal orajectory control for closed loop control of series-parallel resonant converter,” IEEE Trans. Power Electron., vol. 21, no. 5, pp. 1347-1355, Sep. 2006.
[7] G. Hua, F. C. Lee, and M. M. Jovanovic, “An improved full-bridge zero-voltage-switched PWM converter using a saturable inductor,” IEEE Trans. Power Electron., vol. 8, no. 4, pp. 530-534, Oct. 1993
[8] Y. Jang and M. M. Jovanovic, “A new PWM ZVS full-bridge converter,” IEEE Trans. Power Electron., vol. 22, no. 3, pp. 987-994, May 2007.
[9] H. K. Yoon, S. K. Han, and J. S. Park, “Zero-voltage switching two-transformer full-bridge PWM converter with lossless diode-clamp rectifier for PDP sustain power module,” IEEE Trans. Power Electron., vol. 21, no. 5, pp. 1243-1252, Sep. 2006
[10] J. Dudrik, P. Spanik, and N. D. Trip, “Zero-voltage and zero-current switching full-bridge DC-DC converter with auxiliary transformer,” IEEE Trans. Power Electron., vol. 21, no. 5, pp. 1328-1335, Sep. 2006
[11] A. K. S. Bhat, and R. Venkatraman, “A soft-switched full-bridge single-stage AC-to-DC converter with low-line-current harmonic distortion,” IEEE Trans. Ind. Electron., vol. 52, no. 4, pp. 1109-1116, Aug. 2005.
[12] Y. Jang and M. M. Jovanovic, “A new family of full-brideg ZVS converters,” IEEE Trans. Power Electron., vol. 19, no. 3, pp. 701-708, May 2004.
[13] G. B. Koo, G. W. Moon, and M. J. Youn, “Analysis and design of phase shift full bridge converter with series-connected two transformers,” IEEE Trans. Power Electron., vol. 19, no. 2, pp. 411-419, Mar. 2004.
[14] Y. Jang, M. M. Jovanovic, and Y. M. Chang, “A new ZVS-PWM full-bridge converter,” IEEE Trans. Power Electron., vol. 18, no. 5, pp. 1122-1129, Sep. 2003.
[15] M. Marx and D. Schroder, “Analysis of a zero-voltage-transition DC-DC full-bridge converter,” IEEE PESC' 95, pp. 298-303, June 1995.
[16] N. Mohan, T. M. Undeland, and W. P. Robbins, Power Electronics: Converters, Applications and Design, John Wiley and Sons, 1995.
[17] D. Li and X. Ruan, “A high efficient boost converter with power factor correction,” IEEE PESC' 04, pp. 1653-1657, June 2004.
[18] K. P. Louganski and J. S. Lai, “Current phase lead compensation in single-phase PFC boost converters with a reduced switching frequency to line frequency ratio,” IEEE Trans. Power Electron., vol. 22, no. 1, pp. 113-119, Jan. 2007.
[19] M. Chen and J. Sun, “Feedforward current control of boost single-phase PFC converters,” IEEE Trans. Power Electron., vol. 21, no. 2, pp. 338-345, Mar. 2006.
[20] J. Sun, “Input impedance analysis of single-phase PFC converters,” IEEE Trans. Power Electron., vol. 20, no. 2, pp. 308-314, Mar. 2005.
[21] B. Feng and D. Xu, “1-kW PFC converter with compound active-clamping,” IEEE Trans. Power Electron., vol. 20, no. 2, pp. 324-331, Mar. 2005.
[22] F. A. Huliehel, F. C. Lee, and B. H. Cho, “Small-signal modeling of the single-phase boost high power factor converter with constant frequency control,” IEEE PESC' 92, pp. 475-482, July 1992.
[23] P. Cooke, “Modeling average current mode control,” IEEE APEC' 00, pp. 256-262, Feb. 2000.
[24] Y. Jang, M. M. Jovanovic, and D. L. Dillman, “Soft-switched PFC boost rectifier with integrated ZVS two-switch forward converter,” IEEE Trans. Power Electron., vol. 21, no. 6, pp. 1600-1606, Nov. 2006.
[25] F. S. Tsai, “Small-signal and transient analysis of a zero-voltage-switched phase-controlled PWM converter using averaged switch model,” IEEE Trans. Ind. Electron., vol. 29, no. 3, pp. 493-499, May 1993.
[26] V. Vlatovic, J. A. Sabate, and B. Ridley, “Small-signal analysis of the phase-shifted PWM converter,” IEEE Trans. Power Electron., vol. 7, no. 1, pp. 489-498, Jan. 1992.
[27] B. R. Lin, K. Huang, and D. Wang, “Analysis and implementation of full-bridge converter with curent doubler rectifier,” IEE Proc.-Electr. Power Appl., vol. 152, no. 5, pp. 1193-1202, Sep. 2005.
[28] 郭懷天, “全數位化控制的單級功因校正全橋轉換器之研製,” 碩士論文, 國立台灣科技大學電機工程系, 2007年一月.
[29] V. Vorperian, R. Tymerski, and F. C. Lee, “Equivalent circuit models for resonant and PWM switches,” IEEE Trans. Power Electron., vol. 4, no. 2, Apr. 1989, pp. 205-214.
[30] Unitrod Inc., UC3854 High Power Factor Preregulator, 1999.
[31] A. I. Pressman, Switching Power Supply Design, McGRAW-HILL, 1999.
[32] Spectrum Digital, TMS320LF2407A Evaluation Module Technical Reference, 2000.

無法下載圖示 全文公開日期 2011/01/29 (校內網路)
全文公開日期 本全文未授權公開 (校外網路)
全文公開日期 本全文未授權公開 (國家圖書館:臺灣博碩士論文系統)
QR CODE