簡易檢索 / 詳目顯示

研究生: 許家榮
CHIA-JUNG HSU
論文名稱: 雙酚A系環氧樹脂添加無機阻燃劑之研究
The study of the Inorganic Flame Retardant with Bisphenol A series of Epoxy Resin
指導教授: 蘇舜恭
Shuenn-Kung Su
口試委員: 楊銘乾
Ming-Chien Yang
邱士軒
Shih-Hsuan Chiu
學位類別: 碩士
Master
系所名稱: 工程學院 - 材料科學與工程系
Department of Materials Science and Engineering
論文出版年: 2007
畢業學年度: 95
語文別: 中文
論文頁數: 49
中文關鍵詞: 氧氣指數氧化鋁學結晶水
外文關鍵詞: limited oxygen index, aluminum hydroxide, chemical crystal water
相關次數: 點閱:174下載:1
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 本研究所討論之無機阻燃劑應用在塑化材料的組成變化,探討各種不同比例添加劑對基材阻燃性的影響,利用熱分析原理探討材料裂解行為在阻燃機理的作用,再以UL94燃燒測試優劣(CNS 14535)、氧氣指數(CNS 13590)評估試材阻燃性難易及成炭率之效用。
      實驗結果可知無機材料的添加可以促使環氧樹脂提升阻燃性,但需相當比例才可以發揮其阻燃效果,而三氧化二銻單獨添加時效果不佳,但可以和氫氧化鋁有協同效應,可在表面形成保護隔絕空氣,由TGA可知在高溫時可被氣化,降低空氣中的氧含量,氫氧化鋁與三氧化二銻、氫氧化鋁與氫氧化鎂之組合,均可獲得良好之阻燃效用。


    This study was research the component of inorganic flame retardant and application to plastic materials, we have discussion the influence of flame retarded properties with various ratio of additive on matrix, according to thermal analysis, and we also discussed the mechanism affect of degradation behavior of materials with flame retardant, and to used the UL94 burning test, limited oxygen index (CNS 13590) to determined the efficacy of flame retarded properties and charcoals rate.
    The result shows that could protract time to be aflame of epoxy resins as due to the inorganic flame retardant was addition, but its need appropriate ratio to bring the flame retarded effect, this effect was not satisfactory when only addition Antimony trioxide, but it have synergistic with addition aluminum hydroxide at the same time, it’s possible that it will to form a protect film to isolated the air of environment, the TGA thermal properties was show that aeration to decrease the oxygen contents of air at high temperature, furthermore, the composites of aluminum hydroxide with Antimony trioxide, aluminum hydroxide with magnesium hydroxide were obtained the fine flame retarded properties, respectively.

    目錄 頁次 摘要I AbstractII 誌謝III 目錄IV 表目錄VIII 圖目錄VIII 第一章前言及文獻回顧1 1.1.高分子聚合物的分解及燃燒過程2 (1).加熱2 (2).分解2 (3).引燃3 (4).燃燒4 (5).燃燒的傳播4 1.2.阻燃機制5 (1).氣相阻燃機制5 (2).凝聚相阻燃機制:6 (3).熱交換中斷機制:6 1.3.協同機理概述7 1.4.難燃劑之分類8 (1).溴系難燃劑9 (2).氯系難燃劑9 (3).磷系難燃劑9 (4).氫氧化鋁水合物(ATH)9 (5).氫氧化鎂10 (6).三氧化二銻11 (7).氧化鋅12 (8).氧化鐵13 (9).硼酸鋅13 1.5.環氧樹脂硬化劑15 (1).依反應機構分類15 (2).依硬化溫度分類16 (3).依化學構造分類16 1.6.成炭與阻燃17 第二章理論分析19 2.1.塑膠垂直燃燒試驗法(UL-94)19 2.2.氧氣指數法20 2.3.熱重分析儀(TGA;Thermogravimetric Analysis)22 2.4.成碳率和氧氧指數關係23 第三章實驗方法24 3.1實驗藥品24 3.2儀器設備26 3.3實驗步驟27 3.4實驗配比28 (1).測試各無機阻燃劑之燃燒區間28 (2).單一無機阻燃劑添加試驗28 (3).阻燃劑協防作用試驗30 (4).焦炭量與氧氣指數的關係33 第四章結果與討論34 4.1.測試各無機阻燃劑之燃燒區間結果與討論34 4.2.單一阻燃劑添加量改變35 4.3.阻燃劑協防作用試驗38 4.4.焦炭量與氧氣指數的關係41 表目錄 表1 UL-94 試驗條件表19 表2 氧氣指數試樣標準表21 表3 氧氣指數試驗標準表22 表4 單一無機阻燃劑配方29 表5 單一無機阻燃劑配方29 表6-1 多種無機阻燃劑之協防配比31 表6-2 多種無機阻燃劑之協防配比32 表6-3 多種無機阻燃劑之協防配比32 表7 單一阻燃劑添加量改變37 表8-1 阻燃劑協防作用試驗40 表8-2 阻燃劑協防作用試驗41 表9焦炭量與氧氣指數關係表42

    參考文獻
    1、歐育湘,實用阻燃技術,化學工業出版社,(2002)。
    2、A.N.Mauri,C.C.Riccardi,The effect of epoxy excess on the kinetics of anepoxy-anhydride system,Journal of Applied Polymer Science,vol 85,no 11,2342,(2002)。
    3、G.H.Kwank,S.J.Park,J.R.Lee,Viscoelastic behavior of anhydride-cure epoxy system initiated by thermal latent catalyst,Journal of Applied Polymer Science,vol 81,no 3,646,(2001)。
    4、Paril R. Scluilty, blame retavdeig materials,Rubber World,vol 206,no 5,23,(1992)。
    5、王真智,「氫氧化鋁對NBR硫化膠阻燃性能的影響」,橡膠工業,第46卷,第9期,第534~537頁,(2000)。
    6、Barta S, Bielek J, Dieska P. Thermal conductivity and limiting oxygen index of basic rubber blend/aluminum hydroxide particulate composite. Plast Rub and Comp.vol 28,no2,62,(1999)。
    7、E Kazuhisa,N Nobuyuki,S Noriaki. Epoxy resin composition for encapsulating semiconductor. EP-1174455, 2002-01-18。
    8、H shimizu, K Niwa, M Tanaka. Epoxy resin composition and semiconductor device. US-6521354, 2003-02-18。
    9、田春明,「氧化鋅在膨脹阻燃體系中的協效作用」,河北大學學報,第24卷,第6期,第600~604頁,(2004)
    10、趙偉、王麗,「硼酸鋅在LDPE阻燃中的協效作用」,塑料科技,第34卷,第1期,第40~43,(2006)
    11、C.S.Wu,Y.L. Liu,Y.S.Chiu, Epoxy resins possessing flame retardant elements from silicon incorporated epoxy compounds cured with phosphorus or nitrogen containing curing agents. Polymer,vol 16,no 6,1~4,(2000)。
    12、戴焰林、施利毅,氫氧化鎂阻燃劑在聚合物材料中的應用,第32卷,第4期,第4~8頁,(2004)。
    13、Jinhwan Kim,Seokyoon Yoo,Jin-young Bae,et al.Polymer Degradation and Stability,vol 81,207~213,(2003)。
    14、M. Banks,J.R. Ebdon,and M. Johnson, Polymer,vol 34,4547,(1993)。
    15、章思堯,膨脹型石墨製作難燃熱塑性高分子材研究,元智大學化學工程研究所碩士論文,(2001)。

    無法下載圖示 全文公開日期 2008/06/29 (校內網路)
    全文公開日期 本全文未授權公開 (校外網路)
    全文公開日期 本全文未授權公開 (國家圖書館:臺灣博碩士論文系統)
    QR CODE