研究生: |
陳柏祥 Chen,Po Hsiang |
---|---|
論文名稱: |
創新式舌部應用於燃氣爐具之離心風機的性能及噪音優化 Innovative Tonque Applied on Performance and Noise Optimization for Centrifugal Fan |
指導教授: |
林顯群
Sheam-Chyun Lin |
口試委員: |
林榮慶
Zone-Ching Lin 周永泰 Yung-Tai Chou |
學位類別: |
碩士 Master |
系所名稱: |
工程學院 - 機械工程系 Department of Mechanical Engineering |
論文出版年: | 2022 |
畢業學年度: | 110 |
語文別: | 中文 |
論文頁數: | 192 |
中文關鍵詞: | 燃氣離心扇 、流/聲場數值模擬 、創新式舌部 、性能最佳化 、減噪 |
外文關鍵詞: | Gas blower, Numerical flow/acoustic simulations, Innovative tongue, Optimized performance, Noise reduction |
相關次數: | 點閱:197 下載:0 |
分享至: |
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
[1] https://www.liou-tai.net/index.php?route=information/information
[2] https://ebm-papst/condensing-boiler-technology/66514-64034.html
[3] Eck, I. B., “Fans: Design and Operation of Centrifugal, Axial-Flow
and Cross-Flow Fans,” Pergamon Press, New York, 1973.
[4] Liu, C. H., Vafidis, C., and Whitelaw, J. H., “Flow Characteristics of a Centrifugal Pump,” Journal of Fluids Engineering, Vol. 116, pp. 303-309, 1994.
[5] 廖祿甫,渦殼對離心式泵性能的影響,國立成功大學航空太空工程學系碩士論文,1997年。
[6] Raj, D. and Swim, W. B., “Measurements of the Mean Flow Velocity
and Velocity Fluctuations at the Exit of an FC Centrifugal Fan
Rotor,” Journal of Engineering for Power, Vol. 103, pp. 393-399,
1981.
[7] Lin, S. C., “A Novel F-C Centrifugal Fan Design for Improved
Performance,” Department of Mechanical Engineering, Technical
Report, Tennessee Technological University, 1982.
[8] 吳慶財,前傾式離心扇之實驗設計,國立台灣工業技術學院
機械工程技術研究所碩士論文,1993年。
[9] Morinushi, K., “The Influence of Geometric Parameters on F. C.
Centrifugal Fan Noise,” Journal of Vibration, Acoustics, Stress
and Reliability in Design,” Vol. 109, pp. 227-234, 1987.
[10] 許宏祺,Pentium 4 筆記型電腦冷卻風扇之實驗研究,國立台
灣科技大學機械工程技術研究所碩士論文,2001年。
[11] 楊俊欽,高性能、低噪音衛浴排風扇之實驗研究,國立台灣
科技大學機械工程技術研究所碩士論文,2003年。
[12] Gardow, E. B.,“On the Relationship between Impeller Exit
Velocity Distribution and Blade Channel Flow in a Centrifugal
Fan,” Ph.D. Thesis, State University of New York at Buffalo, 1968.
[13] Kjörk, A. and Löfdahl, L., “Hot-Wire Measurements inside a
Centrifugal Fan Impeller,” Journal of Fluids Engineering, Vol. 111,
pp. 363-368, 1989.
[14] Dick, E. and Belkacemi, M., “Optimum Design of Centrifugal Fans
and Pumps,” European Journal of Mechanical Engineering, Vol.
37, pp. 9-18, 1992.
[15] 吳振輝,小型後傾式離心扇之設計,國立台灣工業技術學院機械工程技術研究所碩士論文,1994年。
[16] Leidel, W., “Einfluss Von Zungenabstand und Zungenradius Auf
Kennlinie und Geräusch Eines Radialventilators,” DLR-FB69-16,
1969.
[17]Dong, X. and Dou, H.S., “Effects of Bionic Volute Tongue
Bioinspired by Leading Edge of Owl Wing and Its Installation
Angle on Performance of Multi-Blade Centrifugal Fan,” Journal
of Applied Fluid Mechanics, Vol. 14, No. 4, pp. 1031-1043, 2021.
[18] Hao, Wenyue, Wang, Jiajun, He, Ximing, Zhu, Zuchao, Wang,
Zhengdao, Yang, Hui, Zhang, Wei, and Wei, Yikun. “ Reduction of
Aerodynamic Noise of Single-Inlet Centrifugal Fan with Inclined
Volute Tongue,” Measurement and Control, Vol. 53, No. 7-8,
pp. 1376–1387, 2020.
[19] Yang, Hui, Yu, Peiquan, Xu, Jun, Ying, Cunlie, Cao, Wenbing,
Wang, Yingdong, Zhu, Zuchao, and Wei, Yikun. “ Experimental
Investigations on the Performance and Noise Characteristics of a
Forward-Curved Fan with the Stepped Tongue,” Measurement and
Control, Vol. 52, No. 9-10, pp. 1480–1488, 2019.
[20] Kim, Kwang-Yong and Seo, Seoung-Jin “ Shape Optimization of
Forward-Curved-Blade Centrifugal Fan with Navier-Stokes
Analysis,” Journal of Fluids Engineering, DOI: 10.1115/1.17922
56, 2004.
[21] Zeller, W. and Stang, H., “Predetermination of the Axial-Flow
Fans,” Heizung Luftung Haustchnik, Vol. 9, pp. 10-20, 1957.
[22] Zeller, W., “Concerning Mathematical Treatment of Noise
Behavior in Fans for Air Conditioning Plants,” VID-Berichte, No.
38, pp. 695-708, 1959.
[23] Schlichting, H, “Application of the Boundary Layer Theory to
Flow Problems of Turbo Machines,” Siemens-Zeitschrift, Vol. 33,
No. 7, pp. 74-82, 1959.
[24] Neise, W., “Noise Reduction in Centrifugal Fans: a Literature
Survey,” Journal of Sound and Vibration, Vol. 45, No. 3, pp. 375-403, 1976.
[25] Neise, W., “Review of Noise Reduction Methods for Centrifugal
Fans,” Journal of Engineering for Industry, Vol. 104, pp. 151-161,
1982.
[26] 吳御銓,λ/4減噪器應用在離心扇之數值與實務整合研究,
國立台灣科技大學機械工程系碩士論文,2014年。
[27] Darvish, M., Frank, S., and Paschereit, C. O., “Numerical and
Experimental Study on the Tonal Noise Generation of a Radial Fan,” Journal of Turbomachinery, Vol. 137, No. 10, pp. 1-9, 2015.
[28] Patankar, S. V. and Spalding, D. B., “A Calculation Procedure for
Heat Mass and Momentum Transfer in Three-Dimensional
Parabolic Flows,” International Journal of Heat Mass Transfer, Vol. 15, pp. 1787-1806, 1972.
[29] Su, M. M., Gu, C. A., and Miao, Y. M., “Numerical Study of Viscous Flow Field in Mixed-Flow Fan,” Journal of Xi’an Jiaotong University, Vol. 30, No. 10, pp. 55-63, 1996.
[30] Armone, A., “Viscous Analysis of Three-Dimensional Rotor Flows
Using a Multigrid Method,” NASA TM-106266, 1993.
[31] Lin, S. C. and Huang, C. L., “An Integrated Experimental and Numerical Study of Forward-Curved Centrifugal Fan,” Experimental Thermal and Fluid Science, Vol. 26, pp. 421-434, 2002.
[32] Kokturk, T., “Design and Performance Analysis of a Reversible Axial Flow Fan,” Master Thesis, Middle East Technical University, February, 2005.
[33] Lighthill, M. J., “On Sound Generation Aerodynamically I.
General Theory,” Proceedings of the Royal Society, London, Vol. 211, pp. 564-587, 1952.
[34] 周志成,新型離心式風扇數值與實驗整合研究,國立台灣科
技大學機械工程系碩士論文,台北市,2006。
[35] Liu, Q., Qi, D., and Mao, Y., “Numerical Calculation of Centrifugal
Fan Noise,” Proceedings of Mechanical Engineers, Part C, Journal
of Mechanical Engineering Science, Vol. 220, No. 8, pp. 1167-
1177, 2006.
[36] Lu, H. Z., Huang, L., So, R. M. C., and Wang, J., “A Computational
Study of the Interaction Noise from a Small Axial-Flow Fan,” The
Journal of the Acoustical Society of America, Vol. 122, No. 3,
pp.1404-1415, 2007.
[37] 蔡明倫,風扇性能評估與設計方法之整合研究,國立台灣科
技大學機械工程系博士論文,台北市,2010。
[38] Lin, S. C. and Tsai, M. L., “An Integrated Performance Analysis
for a Small Axial-Flow Fan,” Proceedings of Mechanical
Engineers, Part C, Journal of Mechanical Engineering Science, Vol. 224, No. 9, pp. 1989-1996, 2010.
[39] Lin, S. C. and Tsai, M. L., “An Integrated Study of the Design
Method for Small Axial-Flow Fans, Based on the Airfoil Theory,”
Proceedings of Mechanical Engineers, Part C, Journal of
Mechanical Engineering Science, Vol. 225, No. 4, pp. 885-895,
2011.
[40] Lin, S. C. and Tsai, M. L., “An Integrated Performance Analysis
for a Backward-Inclined Centrifugal Fan,” Computers & Fluids,
Vol. 56, pp. 24-38, 2012.
[41] Lin, S. C., Shen, M. C., Li, C. M., Wang, F. Y., and Yen, H. C., “An
Integrated Numerical and Experimental Investigation on
Improving Acoustic and Cooling Performances of a High-Power Motor,” Transactions of the Canadian Society for Mechanical Engineering, Vol. 41, No. 2, pp. 327-336, 2017.
[42]Bleier, F. P., “Fan Handbook: Selection, Application, and Design,”
McGraw-Hill Education, 1997.
[43]謝旻翰,風機濾網機組之流場數值分析,國立台灣科技大學機
械工程系碩士論文,2008。
[44]游裕傑,離心式電腦風扇的設計與分析,國立成功大學機械工
程學系碩士論文集,2002。
[45] Kim, K.Y, “Shape Optimization of Forward-Curved-Blade
Centrifugal Fan with Navier-Stokes Analysis,” Journal of Fluids Engineerring, Vol. 126, pp. 735-742, 2004.
[46] Launder, B. E. and Spalding, D. B., “Lectures in Mathematical
Models of Turbulence,” Academic Press, London, England, 1972.
[47] Uranga, A., Persson, P., Drela, M., and Peraire, J., “Implicit Large
Eddy Simulation of Transitional Flows over Airfoils and Wings,”
19th AIAA Computational Fluid Dynamics Conference, San
Antonio, Texas, USA, 2009.
[48] Ffowcs Williams, J. E. and Hawkings, D. L., “Sound Generation
by Turbulence and Surface in Arbitrary Motion,” Philosophical
Transactions of the Royal Society of London, Vol. 264, pp. 321-
342, 1969.
[49] Curle, N., “The Influence of Solid Boundaries upon Aerodynamic
Sound,” Proceedings of the Royal Society of London, Series A,
Mathematical and Physical Sciences, Vol. 231, pp. 505–514, 1955.