研究生: |
沈裕桀 Yu-Jie Shen |
---|---|
論文名稱: |
環境降溫對純膨潤土膨脹特性之影響 Influence of Lowering Environmental Temperature on Swelling Characteristics of a Pure Bentonite |
指導教授: |
鄧福宸
Fu-Chen Teng |
口試委員: |
林宏達
Horn-Da Lin 郭治平 Chih-Ping Kuo |
學位類別: |
碩士 Master |
系所名稱: |
工程學院 - 營建工程系 Department of Civil and Construction Engineering |
論文出版年: | 2020 |
畢業學年度: | 108 |
語文別: | 中文 |
論文頁數: | 111 |
中文關鍵詞: | 環境降溫 、純膨潤土 |
外文關鍵詞: | Lowering Environmental Temperature, Pure Bentonite |
相關次數: | 點閱:371 下載:0 |
分享至: |
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
對於低放射性廢棄物最終處置場之多重障壁系統,膨潤土為最重要之緩衝材料,因膨潤土具有良好的吸水膨脹與高吸附核種之特性,可自癒材料並降低水力傳導係數,以減少地下水外滲以及延緩核種外流,但隨著地球氣候變遷,面臨冰河期的到來也將是一個可預知的事件,低放射性廢棄物處置場運行年數高達上百年,面臨環境的降溫能否抵抗,是未來低放射性廢棄物處置場的重要設計因素。目前針對純膨潤土受到環境降溫實驗較少,多部分皆以高溫為取向,因此本研究將使用不同配比之純膨潤土來進行單向度膨脹率試驗,來模擬放射性廢棄物處置場降溫所受之影響。目前針對膨潤土膨脹特性行為之分析較少,本研究探討單元分析軟體Triax對於膨潤土分析之可靠性,Triax中雙重結構擬塑性黏土組成律模式(DSHC model)用以描述膨脹性土壤吸水膨脹、高基質吸力等水-力耦合特性較佳,後續將針對膨潤土受乾溼循環參數校正,以及溫度參數之校正驗證模擬降溫之可行性。本研究校正結果應用於乾溼循環模擬表現良好,建議未來可增加實驗組數增加精確性,但針對溫度參數此模型計算較為簡易,表現較不明顯,建議未來模型可加入更複雜之運算模式來提高溫度參數之靈敏度。
For the multi-barrier system of the low-level radioactive disposal facility, bentonite is the most important buffer material. Because bentonite has high swelling potential and high adsorption ability. These abilities make itself a sealing material and reduce hydraulic conductivity which reduces the possibility of nuclear extravasation by groundwater. However, there will be a foreseen ice age in the future due to the climate change. The low-level radioactive waste disposal site will operate over hundreds of years, so low temperature resistance must be an important design factor for the future radioactive waste disposal sites. At present, there are few experiments on pure bentonite subjected to environmental cooling while the majority are oriented to high temperature. Therefore, this study will use different dry density of pure bentonite to carry out the swelling deformation rate test to simulate the impact of the cooling of the radioactive waste disposal site. At present, there are few analysis on the swelling behavior of bentonite. This study will focus on the unit analysis software Triax for the analysis of bentonite. The Double Structure Hypoplasticity Clay Model (DSHC model) in Triax is used to describe the hydro-mechanical coupling characteristics of bentonite which has better performance of swelling and high suction. Bentonite parametric study focused on dry and wet cycle, while temperature parameter will be calibrated to verify feasibility of cooling simulation. The calibration results of this research have been applied to dry and wet cycle simulations and performed well. It is suggested that the number of experiment can be increased in the future to increase accuracy. However, the calculation of this model for temperature parameters is relatively simple and the performance is less sensitive. It is recommended that, in the future, models can be added with more complex calculation modes to improve the sensitivity of temperature parameters.
1. 王欣婷(2003)。緩衝材料在深層處置場模擬近場環境下回脹行為基礎研究。國立中央大學土木工程研究所碩士論文,桃園市
2. 王東翔(2019)。處置設施緩衝材料之水力耦合模式開發與穩定性分析。國立台灣科技大學營建工程研究所碩士論文,台北市。
3. 台灣電力公司(2015)。低放射性廢棄物最終處置工程障壁中緩衝回填材料調查評估技術服務工作期末報告。
4. 台電公司(2017)。低放射性廢棄物最終處置技術評估報告
5. 周毅修(2019)。緩衝回填材料受乾濕循環作用之膨脹特性研究。國立台灣科技大學營建工程研究所碩士論文,台北市。
6. 張卿茹(2019)。濕化溶液對膨潤土膨脹特性之影響。國立台灣科技大學營建工程研究所碩士論文,台北市。
7. 莊文壽、洪錦雄、董家寶(2000)。深地層處置技術之研究。核研季刊第37期
8. 黃偉慶(2015)。深地層處置設施緩衝材料熱-水力-力學耦合模擬研析。行政院原子能委員會放射性物料管理局。
9. 黃偉慶、葉佐仁、盧俊鼎(2001)。放射性廢料處置場回填材料之工程性質。核子科學,第三十八卷,第二期,第107-118頁。
10. 黃偉慶(2010)。低放射性廢棄物最終處置回填材料於近場環境下之 長期穩定性研究。行政院原子能委員會放射性物料管理局
11. Bukunmi Akinwunmi,Linlin Sun,Janne T. Hirvi,Seppo Kasa,Tapani A. Pakkanen(2018). Influence of temperature on the swelling pressure of bentonite clay.Chemical Physics 516 (2019) 177-181
12. CUI,S.L., DU,Y.F.,WANG, X.P. ,HUANG,S., &XIE,W.L.(2018). Influence of temperature on swelling deformation characteristic of compacted GMZ bentonite-sand mixtures. J. Cent. South Univ. 25: 2819−2830
13. Dufreche, J.F., Marry, V., Bernard, O., and Turq, P.(2001). “Models for electrokinetic phenomena in montmorillonite.” Colloids and Surfaces A: Physicochemical and Engineering Aspects, 195, 171-180.
14. Huang, W.-H., & Chen, W.-C. (2004). Swelling behavior of a potential buffer material under simulated near field environment. Journal of nuclear science technology, 41(12), 1271-1279.
15. Komine, H., & Ogata, N. (1994). Experimental study on swelling characteristics of compacted bentonite. Canadian geotechnical journal, 31(4), 478-490
16. Komine, H. (2004). Simplified evaluation for swelling characteristics of bentonites. Engineering Geology, 71(3-4), 265-279
17. Mitchell, J. K., & Soga, K. (1993). Fundamentals of Soil Behavior, John Wiley&Sons. Inc., New York, 422.
18. Madsen and Muller-Vonmoos, (1989). The swelling behavior of clays.Appl.Clay Sci.,4:143-156
19. Mašín, D. (2005). A hypoplastic constitutive model for clays. International Journal for Numerical and Analytical Methods in Geomechanics, 29(4), 311-336.
20. Masin, D. (2005). Triax User manual.
21. Mašín, D. (2013). Double structure hydromechanical coupling formalism and a model for unsaturated expansive clays. Engineering Geology, 165, 73-88.
22. Mašín, D. (2017). Coupled thermohydromechanical double-structure model for expansive soils. Journal of Engineering Mechanics, 143(9), 04017067.
23. Romero Morales, E. E. (1999). Characterisation and thermo-hydro-mechanical behaviour of unsaturated Boom clay: an experimental study. Universitat Politècnica de Catalunya.
24. Shirazi SM, Kazama H. Swelling properties of bentonite and bentonite-sand mixture for nuclear waste disposal.Australian Geomechanics, 2004, 39 (4): 71-79.
25. Shirazi SM, Kazama H, Chim-oye W and Kuwano J. Effect of void ratio on swelling and permeability of bentonite.Australian Geomechanics, 2008, 43(2): 9-19.
26. Shirazi,S.M.,Kazama,H.,Kuwano,J., & Rashid,M.M(2010).The influence of Temperature on Swelling Characteristics of Compacted Bentonite or Waste Disposal. EnvironmentAsia 3(1)60-64.
27. SKB(2006),Long-term safety for KBS-3 repositories at Forsmark and Laxemar-a first evaluation. Main Report of the SR-Can Project, SKB Technical Report,TR06-09,SKB, Stockholm.
28. SKB(2010).Design, production and initial state of the buffer. Svensk Ka¨rnbra¨nslehanteringAB,SKBTR-10-49,Stockholm,Sweden,Report