簡易檢索 / 詳目顯示

研究生: 鄒騰鋒
TSOU - TENG FENG
論文名稱: 電致發光顯示器之驅動變頻器研製
Study and Implementation of the Driving Inverter for an Electroluminescent Display
指導教授: 羅有綱
Yu-Kang Lo
口試委員: 劉益華
Yi-Hua Liu
歐勝源
Sheng-Yuan Ou
學位類別: 碩士
Master
系所名稱: 電資學院 - 電子工程系
Department of Electronic and Computer Engineering
論文出版年: 2007
畢業學年度: 95
語文別: 中文
論文頁數: 77
中文關鍵詞: 電致發光顯示器驅動器SPWM
外文關鍵詞: The Driving Inverter for an Electroluminescent D
相關次數: 點閱:153下載:0
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報

本論文主要研製一適用於電致發光顯示器(Electroluminescent Display,ELD)之驅動電源,其主電路架構採用昇壓型功率因數修正轉換器及全橋變頻器兩級串接的形式實現,以提供ELD所需的交流電源。架構中之SPWM控制信號由PIC16F873A微控制器產生,可以有效降低ELD驅動電流,使其遠小於10mA/nF,有利於延長ELD壽命。至於驅動IC的電源部分,本文製作輔助電源分別供電給PIC微控制器及閘極驅動電路,方便直接以市電運作。而本文中亦實現輸出亮度控制電路,在ELD產生老化現象時(內部等效電容值會逐漸下降,而內部等效電阻值會逐漸上升),調整變頻器輸出頻率,維持ELD之輸出亮度,增加ELD的有效工作時間。


A suitable AC power supply for the Electroluminescent Display is presented in this thesis. The circuit mainly consists of a front-stage power factor corrector and a single-phase full-bridge inverter. A PIC16F873A microcontroller produces SPWM signals which can reduce the ELD driving current to be much lower than 10mA/nF and help to extend the lamp lifetime. An axuiliary power supply is designed for the PIC microcontroller and the PowerMOS gate driver, so that the circuit can be directly operated via AC line. The output brightness control circuit is also proposed in this thesis. After a long time of usage and the aging of ELD happen, the circuit will adjust the output frequency to maintain the ELD output brightness and increase the effective working hours.

摘 要 i Abstract ii 誌 謝 iii 目 錄 iv 符號索引 vii 圖表索引 ix 第一章 緒論 1 1.1 研究背景 1 1.2 研究動機 2 1.3 章節介紹 2 第二章 AC薄膜ELD內部動作原理 3 2.1 ELD簡介 3 2.1.1 ELD分類 4 2.1.2 ELD特性 5 2.1.3 ELD應用層面 6 2.2 AC薄膜ELD 6 2.2.1 ELD內部結構 6 2.2.2 ELD冷光的產生過程 8 2.2.3 AC薄膜ELD動作原理 9 第三章 ELD弦波驅動電源 14 3.1 基本架構 14 3.2 非連續模式功率因數修正器 15 3.2.1 L6561電路規格 19 3.2.2 輸入電感值的圈數 19 3.2.3 線徑選擇 20 3.2.4 輔助電源 20 3.2.5 輸出電容值 20 3.2.6 功率開關 21 3.2.7 主二極體 21 3.2.8 橋式整流器的選擇 21 3.2.9 功率損耗分析 21 3.3 單相變頻器 23 3.3.1 半橋式變流器 23 3.3.2 全橋式變頻器 25 3.4 SPWM介紹 26 3.4.1 SPWM單電壓極性切換訊號製作 32 3.4.2 PIC16F87X微控制器介紹 33 3.5 驅動電路 40 3.6 濾波電路設計 42 3.7 輔助電源 46 3.7.1 電路規格 47 3.7.2 耦合電感一次側繞組圈數的計算 47 3.7.3 空氣間隙長度的計算 48 3.7.4 耦合電感二次側繞組圈數的計算 48 第四章 ELD輸出亮度控制電路 50 4.1 變頻控制電路 51 4.2 輸出電流取樣電路 52 4.3 判斷電路 53 第五章 實驗結果 55 5.1 主動式功率因數修正電路實測波形及數據 55 5.1.1 電路實測波形 55 5.1.2 電路實測數據 56 5.2 變頻器電路實測波形及數據 58 5.2.1 電路實測波形 58 5.2.2 電路實測數據 66 5.3 方波驅動與弦波驅動比較實測波形及數據 70 5.3.1 電路實測波形 70 5.3.2 電路實測數據 72 第六章 結論與建議 74 6.1 結論 74 6.2 未來研究方向 75 參考文獻 76

[1] 黃柏棋,“電致發光顯示器驅動電源研製”,國立台灣科技大學碩士學位論文,中華民國九十四年七月。
[2] Aircraft Extras inc. http://www.aircraftextras.com/EL-Panel1.htm
[3] Yoshimasa, A. Ono “Electroluminescent Displays” in 1995.
[4] I I.Boonyaroonate, and S.Mori, “Half-bridge inverter using hysteresis currentcontrol for electroluminescent lamp,” IEEE TENCON, vol.2, pp.796- 798, 2001.
[5] 宋自恆、林慶仁,「功率因數修正電路之原理與常用元件規格」,新電子科技雜誌217期,民國94年四月。
[6] ST Microelectronics, “L6561 Power factor corrector,” Data Sheet, 1999.
[7] ST Microelectronics, “L6561, Enhanced transition mode power factor corrector,” Application Note AN-966, October 2001.
[8] Daniel W. Hart 著,王順忠譯,「電力電子學」,民國87年,東華書局。
[9] Muhammad H. Rashid 著,張天錫譯,「電力電子學」,第三版,民國93年,東華書局。
[10] Mohan.Undeland.Robbin 著,江炫章編譯,「電力電子學」,第三版,民國92年,全華科技圖書。
[11] 施慶隆著,「PIC16F87X微控制器原理實習與專題應用」,修訂版,民國92年,全華科技圖書。
[12] Microchip, “PIC16F87Xa 28/40/44-Pin enhanced flash microcontrollers,” Data Sheet, 2003.
[13] International Rectifier, “IR2184 HALF-bRIDGE dRIVER”, Data Sheet, 2001
[14] 許元豪,「DSP控制UPS正弦穩壓的分析、設計與實現」,國立交通大學碩士學位論文,中華民國八十七年九月。
[15] S. Bumrungkeeree, and I. Boonyaroonate, “Push-pull dc/ac inverter for large electroluminescent lamp,” IEEE ISCAS, vol.3, pp.359-362, 2003.
[16] Power Integrations, Inc. “TOPSwitch® flyback design methodology,” Application Note AN-16, June 1996.
[17] 梁適安著,「交換式電源供應器之理論與實務設計」,民國83年,全華科技圖書。
[18] Sipex “EL Technology Overview.”

無法下載圖示 全文公開日期 2012/07/05 (校內網路)
全文公開日期 本全文未授權公開 (校外網路)
全文公開日期 本全文未授權公開 (國家圖書館:臺灣博碩士論文系統)
QR CODE